Pulnix TS-9720EN Series Instrukcja Instalacji Pobierz pdf (Strona 53)

Page 41

VIS CAM 300/400 Installation Manual

System Set-Up

FIGURE 36. Focus Bar Waveform Display with waveform cursors.

9. Use one hand to carefully hold the focus ring of the lens in place while you rotate the filter ring on

the very front of the lens with your other hand. Turn the filter ring until the white mark on the ring

is oriented straight up (or down). Secure the filter ring in place with a small dab of RTV glue.

10. Printout the image of the screen using the “File -> Print…” menus on both the “Video Window”

and the “Focus Bar Waveform” windows to document the settings. If no printers are connected, the

“PDFCreator” printer driver can be used to save the pictures as PDF-files.

11. Have your assistant move the plate stand back to the near trigger line and re-position the plate at the

minimum plate height.

12. Drive the setup vehicle slowly towards the trigger line in the same heading as normal traffic flow

and center it directly between the camera being aligned and the adjacent camera that has already

been aligned. Marking the position halfway between adjacent cameras at the trigger line with some

marker is advisable to help the driver properly aim the vehicle.

13. Park the vehicle at the location where it just barely causes the trigger to cause an image to be cap-

tured. For loop triggers, park the vehicle where a vehicle would normally be located when the loop

trigger signals the VIS to capture an image.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 115 116

Brak uwag

Pulnix TS-9720EN Series Instrukcja Instalacji Strona 53