Pulnix TMC-6700 Series Instrukcja Obsługi Pobierz pdf (Strona 19)

Page 11

Installation

TMC-6700/1000 Series Progressive Scan CCD Digital Color Camera

2.2.3 RS-232C Cosmmunication Cable and Connector

FIGURE 4. CBL-RS232-9 Cable

The RS-232 controller set CS-232C includes CBL-RS232-9 interface cable, software diskette, and a

quick-start card. The TMC-6700/1000 series camera’s built-in DSP chip can be controlled by an

external RS-232C interface. The camera settings can be programmed or changed using the

communication cable and software. Please refer to the software manual for details on the graphical user

interface.

2.2.4 Digital Output Cables

The selection of an appropriate digital output cable depends on whether you are using a Channel Link

frame grabber or a non-Channel Link frame grabber. PULNiX offers two digital output cables. The

Channel Link/TTL Adapter cable (15CL-02) provides 24 bit TTL output for use with a non-Channel

Link frame grabber. The Direct Channel Link cable (15CL-02-15) should be used with a Channel Link

frame grabber. Please check PULNiX’s website (www.pulnix.com) for a list of compatible Channel

Link frame grabbers.

2.2.4 (a) Direct Channel Link Cable

FIGURE 5. Direct Channel Link Cable (15CL-02-15) (base only)

This cable is for use with Channel Link frame grabbers. It has a 15-pin Airborne connector on the

camera end and a 15-pin high-density, D-sub connector on the frame-grabber end.

Not all Channel Link frame grabbers have a 15-pin input connector, in which case a custom adapter

cable will be needed. The pin assignment for the digital connector is show in Section 2.2.1 (b on page 7.

Contact your PULNiX representative if you need assistance.

2,000.0mm ±25mm (2 meters)

25.0mm±2mm

2,000mm ± 10mm(2 meters)

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 47 48

Brak uwag

Pulnix TMC-6700 Series Instrukcja Obsługi Strona 19