Pulnix TMC-6700 Series Instrukcja Obsługi Pobierz pdf (Strona 17)

Page 9

Installation

TMC-6700/1000 Series Progressive Scan CCD Digital Color Camera

2.2.2 Power Supply and Power Cable Setup

2.2.2 (a) Power Supplies

The TMC-6700/1000 series requires 12V DC. Power is obtained through the 12-pin connector located

at the rear of the camera. PULNiX recommends the following power supplies:

K25-12 110V AC/12V DC 2.1A power supply

K50-12 110V AC/12V DC 4.2A power supply

PD-12UU 110V AC/12V DC 0.5A power supply

PD-12UUP 12-pin connector US plug

PD-12UE 110V AC/12V DC 0.5A European power supply

PD-12UEP 12-pin connector European plug

For users providing power through the 12-pin connector, the PD-12P, PD-12UUP, and PD-12UEP

power supplies are available with the 12-pin mating connector already attached to the leads from the

power supply. The PD-12 power supply can be connected to the PULNiX power cable via a terminal

strip or directly.

When wiring the PD-12 power supply directly, please note the following:

• The lead ends must be twisted together and tin-soldered for strength and electrical continuity.

• Shrink tubing or a similar insulator should be used to prevent exposed leads from touching and

shorting.

• The +12V lead is marked with a red stripe or white lettering; be sure not to reverse the leads.

• All connections must be properly insulated to prevent shorting.

5 Tx CLK OUT - Out 18 Tx CLK OUT + Out

6 Tx OUT 3 - Out 19 Tx OUT 3+ Out

7 SerTC+ In 20 SerTC - In

8 SerTFG- Out 21 SerTFG+ Out

9 VINIT - (CC1-) In 22 VINIT + (CC1+) In

10 INTEG + (CC2+) In 23 INTEG- (CC2-) In

11 N/C 24 N/C

12 N/C 25 N/C

13 GND 26 GND

TABLE 3.

26-Pin CL Connector Pinout Configuration (Continued)

Camera Link Connector MDR 26-Pin Connector 10226-6212VC

Pin # Description I/O Pin # Description I/O

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

Brak uwag

Pulnix TMC-6700 Series Instrukcja Obsługi Strona 17