Pulnix TS-9720EN Series Instrukcja Obsługi Pobierz pdf (Strona 12)

Page 4

Getting Started

TS-9720EN Series Progressive Scan Shutter Cameras

2.2.2 Changing the IP Address of the TS-9720EN Camera

If you need to change the IP address of your TS-9720EN camera, you can do so using either the EN

setup software or the debug RS-232 serial/power cable. Choose the method that is most appropriate for

your application, and follow the steps listed.

2.2.2 (a) Changing the IP Address of the TS-9720EN Camera Using the EN Setup Software

You can use the EN setup software to change the IP address of the TS-9720EN camera. To so do, follow

the steps below.

1. First, set up your PC’s network setting properly so that your PC has the 10.0.0.XX subnet.

However, XX must not be 65, because the host PC’s IP address cannot be the same as that of the

camera. The subnet address must be 255.255.255.0.

2. Next, open the EN setup software. If you are starting this software for the first time, you will be

asked to type your password. Your case-sensitive user name and password are as follows:

User name: Administrator

Password: Password

3. Click the “Properties” button. You will see the EN cameras that are in the network.

4. Click the icon of the camera you want to change. Once it is selected, find the “IP address” register

and change the IP address of the camera.

5. Right-click on the camera icon and select “Reboot.” This option will reboot the camera.

6. The camera will now start up with a new IP address.

2.2.2 (b) Changing the IP Address of the TS-9720EN Camera Using the Debug RS-232 Serial/

Power Cable

You can use the debug RS-232 serial/power cable to access the BIOS menu and change the IP address of

the TS-9720EN camera. To do so, follow the steps below.

1. First set up your hyperterminal as 9600-8-N-1. Start up the TS-9720EN. You should now see the

BIOS start-up code.

2. Type “/” to stop the normal camera boot-up and to start the BIOS test mode.

3. Type “3” to select the “IP address change” setting.

4. Type “1” to select the first network interface, and then “1” again to change the local IP address.

5. Type the IP address you want to change.

6. Type “0” to return to the main menu, and then type “0” to start up the normal boot-up.

2.3 Installing the Required Software

The EN setup software is used to change the registers of the camera parameters, display live video

images, and sniff hardware/trigger Ethernet from the lane controller. To install the software required for

the TS-9720EN, run “Setup.exe” from the CD-ROM. This will guide you through the proper

installation. Once the software is loaded on your system, find the “EN Setup” software from the Start

menu (Start -> EN Setup -> EN Setup). If you are logging in for the first time, you must enter the

following case-sensitive user name and password:

User Name: Administrator

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 62 63

Brak uwag

Pulnix TS-9720EN Series Instrukcja Obsługi Strona 12