Pulnix TM-5LC Instrukcja Obsługi Pobierz pdf (Strona 12)

INSTALLATION

Page 6 TM-5LC Super-Miniature Cylindrical CCD Camera

Note:

The “K” series power supplies are designed primarily for OEM users who will be

mounting the power supply inside a protective enclosure. For use in exposed situations,

the PD-12 and PD-12U are recommended.

2.2.3 Attaching the Camera Lens

The TM-5LC camera accepts a specialized miniature 1/4" format size Tamron lens mount. To attach the

Tamron lens to the camera, carefully engage the threads and rotate the lens clockwise until it ﬁrmly

seats on the mounting ring. Do not force the lens if it does not seat properly. Please note that some

lenses with extremely long ﬂangebacks may exceed the mounting depth of the camera.

2.2.4 Attaching the C/CS-Mount Adapter and Lens

An optional C/CS-mount adapter (part number 32-3663) can be used with the TM-5LC. Any C/CS-

mount lens can be used on the TM-5LC with this adapter. In order to determine the position of the lens

and the adapter, the following procedure should be implemented:

Attach the lens to the adapter.

Loosen the set screws on the adapter and slide it over the camera body.

Set the lens focus to inﬁnity and point the camera at a distant object.

Slide the adapter up/down until the image is in focus.

Tighten the three set screws on the adapter.

2.2.5 Auto-Iris Lens Setup

The TM-5LC camera does not come equipped with auto-iris output. It is possible to use an auto-iris lens

with full video input with the TM-5LC. The following procedure should be followed to connect an auto-

iris lens to the TM-5LC.

Power down the camera before installing the auto-iris lens.

Note:

Make sure that the power is removed from the camera before connecting or disconnecting

the auto-iris lens. There is a small chance that damage could occur to the auto-iris lens by

plugging or unplugging it while the camera is powered up.

Wire the video signal lead on the lens into the terminal 1 V peak to peak video output on the

camera.

Point the camera at a light area and then quickly towards a dark area. If everything is working prop-

erly, the iris should adjust for light change.

2.2.6 Monitor Display Mode

For monitoring real time video, connect the video output to an RS-170 video monitor or other device, as

shown in Figure 1.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19

Brak uwag

Pulnix TM-5LC Instrukcja Obsługi Strona 12